Published on August 24, 2026 at 5:18 pm
A refrigeration system that is low on charge doesn’t stop. It keeps running, just worse: longer run times, poorer cooling capacity, a compressor that runs hotter than it should, and an electricity bill that slowly creeps up. That is exactly why leaks are usually only noticed once the system has already been damaged.
And once it’s clear that something is escaping, the real work begins: finding out where.
What It Is
A refrigerant leak detector for air conditioners and cooling systems.
- Heated diode sensor — detects all common refrigerants
- Three selectable sensitivity levels: 0.75 / 1.5 / 3.0 cl per year
- Audible and visual alarm, with mute button
- LED light at the probe tip, switchable separately
- Field-replaceable sensor and LED tip
- Battery indicator; complete with leak test bottle, 9V battery and hard case
Why the Sensitivity Is Adjustable
The most common user error is going straight to the highest setting. In a machine room where refrigerant has escaped before, some residue often remains in the air. A highly sensitive device then alarms everywhere, and the display only tells you that you’re in the right room.
The method that works is the reverse: start at the lowest sensitivity and slowly trace along the line. If the device alarms, you’re already close. Only then do you raise the sensitivity step by step to narrow down the location, and in between you purge the probe in clean air so that it resets to a zero reading. A device that beeps constantly becomes a device that points to a threaded connection.
The sensitivity rating is a leak rate per year, not a concentration. That is the crucial point: it isn’t about how much refrigerant is currently in the air, but about how small a loss you can still detect, because what matters is whether a system loses its charge over the course of a season.
The Sensor
A heated diode responds specifically to halogenated compounds, which is precisely the group of substances that the common refrigerants belong to. This matters more in daily use than it sounds: a non-specific sensor also alarms on solvent vapors, cleaning agents or leak detection spray, and every such false alarm costs time to rule out.
The sensor is a wear part, and that is by design. A heated element ages in operation. Whether it can be replaced in the field determines whether the device is still in use after two years or has to be replaced. And the included leak test bottle lets you quickly check that it’s working before every job, rather than relying on a device that is silent.
Three Typical Applications
- Refrigeration and air conditioning: Leak detection at threaded connections, solder joints and heat exchangers during maintenance and troubleshooting.
- Vehicle air conditioning: Checking lines and the condenser, where vibration and road salt are the typical causes.
- Leak testing after repair: Proof that the repaired spot is truly tight before the system is recharged.
Why It Pays Off
Refrigerant is expensive, and topping up without finding the leak means paying for it a second time, and next time including the call-out. Then there’s efficiency: an undercharged system permanently consumes more electricity, and that loss continues every day until the cause is found.
The biggest item, however, is the compressor. It is cooled by the returning refrigerant; if the charge is low, it runs hot, and replacing it costs many times more than any leak search. A device that lets you check a threaded connection in minutes shifts maintenance to exactly where it is cheapest: before the damage.